The height is set by your bowl, not by taste
A tall tap exists for one reason: a bowl that sits on the worktop rather than in it. That makes the geometry arithmetic rather than taste — the spout has to clear the rim of your bowl and still point inside it. The figure to read is spout height measured from the tap hole, not overall height, because the part below the worktop tells you nothing. Add the rim height of your bowl, allow a few centimetres of air, and you have the minimum. Too tall is a real fault too: water falling from 25 cm into a shallow bowl splashes onto the worktop, and no amount of aerator fixes it. Spout reach should land the stream near the middle of the bowl, roughly half the bowl diameter. We compare overall height, spout height above the tap hole, spout reach, stated flow rate with its test pressure, cartridge diameter, and finish.
Tall basin mixer · brass · spout height 8.93 in (about 227 mm) · reach 6 in (about 152 mm) · hole 33–45 mm
The most completely dimensioned tap in this catalogue: a spout height, a spout reach and a tap hole range, all published — in inches, by a maker of antique brass fittings.
Best for: A countertop bowl whose rim height is known, in a bathroom where the finish is period rather than modern.
≈ £36 / 36 €
Tall basin mixer · ComfortZone 190 mm stated · AirPower aeration · G3/8 DN15 · suitable for instantaneous heaters · no waste supplied
A tall mixer that publishes 190 mm of clearance under the spout, states its connection size, and says it suits an instantaneous water heater — three facts that let it be specified rather than hoped at.
Best for: A countertop bowl whose rim height is known, on a basin that already has its waste.
≈ £100 / 88 €
Tall basin mixer · lead-free 304 stainless stated · spout and body both rotate 360° · ceramic cartridge, 500 000 cycles
A tall chrome mixer in stated lead-free 304 stainless whose body rotates as well as its spout, with a cartridge the maker states has passed 500 000 cycles.
Best for: A bowl reached from two sides, where the extra movement is genuinely used and the rim height is modest.
≈ £51 / 46 €
Tall basin mixer · 59 brass stated · spout height 9.6 in (about 244 mm) · reach 6.3 in (about 160 mm) · 3/8 in connection
A tall antique brass mixer that publishes its height, its reach, its hole range and its alloy — and is the tallest spout on this page by a clear margin.
Best for: A deep countertop bowl with a high rim, where a shorter tall tap would not clear.
≈ £47 / 41 €
Tall basin mixer · 30 cm stated overall height · pop-up waste and 3-in-1 tool · metal lever · StarLight chrome
A tall mixer with a metal lever, a hardened chrome finish and a complete box — a pop-up waste, the fixing material and the installation tool.
Best for: A countertop bowl on a basin with an overflow, bought as one parcel rather than as a tap plus two more orders.
≈ 83 €
